![]() ![]() ![]() Outward pressure, not inward, which I find odd since I read the LDP should only pressurize the tank by about. Also, if I open my fuel cap at that same moment it is smelling of gas it lets out a lot of pressure. Coincidentally, or not, I have noticed that when starting the vehicle under these same conditions I notice a very strong fuel smell coming from around my fuel filler cap, which is also the same area the fuel tank vent valve is. I understand that the fuel system is pressurized and tested for leaks by the LDP only when the vehicle is on a cold start, under around 90 degrees outside, and with under 85% full. So here is where I'll add a little more info to see if it helps solve my issue before I go spending $200 on a LDP that isn't confirmed as the issue. The technician who did the smoke test said that since no smoke leaks were found it could be the leak detection pump or evap purge valve. I have inspected all lines and rubber connections, and don't see any issues. See your road more clearly with bright and easy-to-install AUXITO LED. I've had the system smoke tested, it came back with no leaks found. Ultimate light beam pattern for your Car LED forward, interior & exterior lighting. ![]() Now it has gone to a medium evap leak engine light code. I replaced the gas cap with a Jeep cap and reset the light. About 2 months ago I had the small emissions leak engine light code come on. Any help would be much appreciated in helping me resolving this issue! I've read and searched countless forums with no resolve. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |